s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 383

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
(3) Re-enabling a disabled breakpoint
(4) Disabling a valid breakpoint
An already set breakpoint number can be specified. In this case, the breakpoint is changed to a newly input
address. All set breakpoints are enabled (/E).
A break address that is set for some other breakpoint number cannot be specified. If duplicate break
addresses are specified, an error results.
When the above example is executed, the breakpoint list is modified as shown below:
No break occurs at breakpoints whose addresses are marked with /D (No. 3 in the above example). To
re-enable such a disabled break, execute one of the commands shown below:
Format 1) After displaying the current settings, input the following command:
An error results if you specify a breakpoint number that has no address set.
To quit in the middle of guidance, input only the [Enter] key and nothing else.
Format 2) Input the following command:
A break occurs at breakpoints whose addresses are marked with /E. To disable one of these breakpoints
while leaving its set address intact, execute a command as shown below:
Format 1) After displaying the current settings, input the following command:
An error results if you specify a breakpoint number that has no address set.
To quit in the middle of guidance, input only the [Enter] key and nothing else.
Format 2) Input the following command:
...Enables breakpoint No. 3.
...Breakpoint No. 3 is marked with /E, indicating that it has been enabled.
...Disables breakpoint No. 2.
...Breakpoint No. 2 is marked with /D, indicating that it has been disabled.
EPSON
...Input a breakpoint No. to be re-enabled.
...Choose "2. enable".
...Input the breakpoint number to be disabled.
...Choose "3. disable".
CHAPTER 16: DEBUGGER
367