s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 74

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 5: WORK BENCH
5.2.4 Executing Individual Tools
Each software tool can be executed using the buttons in the execution window.
To execute a software tool
About [Stop] button
The following outlines the files input and output by each software tool and the startup options of each tool that
can be selected by the wb33. (For make, refer to Section 5.2.6.) Explained below is the function of each option
when selected.
For more information, refer to the chapters where each tool is detailed.
C Compiler gcc33
58
When you choose the [smaller font] check box of the [other options] window, the font size in the output
window is reduced, allowing for a greater amount of information to be displayed at a time.
1. Choose the startup options of the tool you want to be executed in the execution window.
2. Choose the file you want to be input to a software tool using the file list box and click on the tool's
Once you execute a software tool using the execution button, processing cannot be stopped in the wb33
until the tool (including make) finishes processing. However, if the tool is executed after selecting multiple
files, processing can be halted by using the [Stop] button. Since a software tool processes one file at a time
no matter how many files are selected, execution of the tool is halted when it finishes processing the file
that was being processed when you clicked on the [Stop] button.
Execution button:
Input file:
Output file:
Options:
execution button.
Multiple input files can be selected. In this case, the software tool is executed repeatedly as many times
as the number of files selected.
[Stop] button
*.c (C source file; lower-case is only allowed for ".c", ".C" cannot be used.)
*.ps (assembly source file bearing the same name as input)
†debug info: Selection of the -g option (turned on by default)
The information required for the C source level debug is generated in the output file.
Normally, you should choose this option.
EPSON
The 10-point Terminal font is used for the
reduced display. If this font is not installed in
your system, the effect of [smaller font] cannot
be guaranteed. The default font is 14-point
FixedSys.
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
S5U1C33000C MANUAL