s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 423

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
(3) Registering structures or arrays collectively
Notes
Symbols can only be registered and displayed if the srf33 format object file that contains debugging
information is read into the debugger.
No structures or arrays can be registered collectively by using the [Add] command on the [Symbol] menu or
the [Symbol add] button. Therefore, users cannot select symbols by placing the cursor in front of "->" or ".".
An error results if the specified symbol cannot be found.
If the specified symbol is out of the scope or it points to a no-map area, the symbol information is displayed
as below.
The maximum number of symbols that can be registered is 99. If this limit is exceeded, an error results.
Symbols can also be registered by using the [Add] command on the [Symbol] menu or the [Symbol add]
button.
Place the [Source] window in the mixed or source display mode, then place the cursor in or immediately
before or after the symbol name that you want registered. Then click on the [Symbol add] button or choose
the [Add] command from the [Symbol] menu to register the symbol in the watch symbol table. Information
on this symbol is displayed in the [Symbol] or the [Command] window.
These menu commands and buttons can be selected only when the [Source] window is active. No display
format can be set. Information is displayed in the default format that conforms to the selected symbol type.
Structures or arrays can be registered collectively by using the formats shown below.
The collective registration function cannot be executed using menu commands or buttons.
[Symbol add] button
Error: Symbol not found.
<symbol> = out of the scope, ....
<symbol> = symbol points to no map area, ....
Error: Cannot add symbol any more.
EPSON
...Symbol cannot be found.
...Symbol is out of the scope.
...No-map area is pointed.
CHAPTER 16: DEBUGGER
407