s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 404

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

CHAPTER 16: DEBUGGER
388
(3) Clearing area break conditions
Notes
The ba command can only be used in the ICD+MEM33 mode.
For extended break using S5U1C33001M1, the target does not stop immediately after a break because the
break makes use of the S5U1C33000H external break.
An error occurs if the top address and the bottom address are not located in the same CE area.
An error occurs if the internal memory area is specified.
The top address and the bottom address must be an area which can be accessed by the CEFUNC specified in
the parameter file. The following message is displayed when an error occurs:
If the specification of the parameter file and the configuration of BCU are different, a break will not occur
correctly. Be aware that the BCU configuration is initialized to default settings after a cold reset.
Use this command so that the S5U1C33001M1 address and the target memory do not conflict.
Format 1) After displaying the current settings, input a command as shown below:
Area break 2 will be cleared.
Format 2) Input a command as follows:
Area break 2 will be cleared.
(current settings)
Error: Top address and bottom address should be same CE.
Error: MEM33 is not supported at area0, area1 and area2 (0-0x7FFFF).
Error: Invalid address or invalid CEFUNC of parameter file.
...Specify area break 2.
...Choose "2. clear".
EPSON
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
S5U1C33000C MANUAL