XIO2000AI TAOS [TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS], XIO2000AI Datasheet - Page 138

• Manufacturer Part Number: XIO2000AI
• Description: PCI Express to PCI Bus Translation Bridge
• Manufacturer: TAOS [TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS]

Memory-Mapped TI Proprietary Register Space
6.22 Serial-Bus Control and Status Register
† These bits are reset by a PCI Express reset (PERST), a GRST, or the internally-generated power-on reset.
128
BIT
7†
5†
4†
3†
2†
1†
0†
6
SCPS155C
The serial-bus control and status register controls the behavior of the serial-bus interface. This register also
provides status information about the state of the serial-bus. This register is an alias for the serial-bus control
and status register in the PCI header (offset B3h, see Section 4.58). See Table 6−11 for a complete description
of the register contents.
RESET STATE
BIT NUMBER
FIELD NAME
SBDETECT
PROT_SEL
ROMBUSY
ROM_ERR
REQBUSY
Device control memory window register offset:
Register type:
Default value:
SB_ERR
SBTEST
RSVD
Table 6−11. Serial-Bus Control and Status Register Description
ACCESS
RWU
RCU
RCU
7
0
RW
RW
RU
RU
R
6
0
Protocol select. This bit selects the serial-bus address mode used.
Reserved. Returns 0b when read.
Requested serial-bus access busy. This bit is set when a software-initiated serial-bus cycle is in
progress.
Serial EEPROM access busy. This bit is set when the serial EEPROM circuitry in the bridge is
downloading register defaults from a serial EEPROM.
Serial EEPROM detected. This bit enables the serial-bus interface. The value of this bit controls
whether the GPIO4//SCL and GPIO5//SDA terminals are configured as GPIO signals or as
serial-bus signals. This bit is automatically set to 1b when a serial EEPROM is detected.
Note: A serial EEPROM is only detected once following PERST.
Serial-bus test. This bit is used for internal test purposes. This bit controls the clock source for the
serial interface clock.
Serial-bus error. This bit is set when an error occurs during a software-initiated serial-bus cycle.
Serial EEPROM load error. This bit is set when an error occurs while downloading registers from a
serial EEPROM.
0 = Slave address and word address are sent on the serial-bus (default)
1 = Only the slave address is sent on the serial-bus
0 = No serial-bus cycle
1 = Serial-bus cycle in progress
0 = No EEPROM activity
1 = EEPROM download in progress
0 = No EEPROM present, EEPROM load process does not happen. GPIO4//SCL and
1 = EEPROM present, EEPROM load process takes place. GPIO4//SCL and GPIO5//SDA
0 = Serial-bus clock at normal operating frequency ~ 60 kHz (default)
1 = Serial-bus clock frequency increased for test purposes ~ 4 MHz
0 = No error
1 = Serial-bus error
0 = No Error
1 = EEPROM load error
5
0
GPIO5//SDA terminals are configured as GPIO signals.
terminals are configured as serial-bus signals.
4
0
3
0
2
0
1
0
47h
Read-only, Read/Write, Read/Clear
00h
DESCRIPTION
0
0
April 2007 Revised October 2008