HD6417709SF133B Renesas Electronics America, HD6417709SF133B Datasheet - Page 701

• Manufacturer Part Number: HD6417709SF133B
• Description: IC SUPERH MPU ROMLESS 208LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417709SF133B

• Core Processor: SH-3
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: EBI/EMI, FIFO, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 96
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.65 V ~ 2.05 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -

Data loaded into the output pin boundary scan register in the Capture-DR state is not used for
external circuit testing (it is replaced by a shift operation).
The instruction code is 0000.
22.5.2
1. Boundary scan mode covers clock-related signals (EXTAL, EXTAL2, XTAL, XTAL2,
2. Boundary scan mode does not cover reset-related signals (RESETP, RESETM, CA).
3. Boundary scan mode does not cover UDI-related signals (TCK, TDI, TDO, TMS, TRST).
4. When a boundary scan test is carried out, ensure that the CKIO clock operates constantly.
5. Fix the RESETP pin low.
6. Fix the CA pin high, and the ASEMD0 pin low.
22.6
1. An UDI command other than an UDI interrupt, once set, will not be modified as long as
2. Because chip operations are suspended in standby mode, UDI commands are not accepted.
3. The UDI is used for emulator connection. Therefore, UDI functions cannot be used when
22.7
The AUD is a function exclusively for use by an emulator. Refer to the User's Manual for the
relevant emulator for details of the AUD.
CKIO).
The CKIO frequency range is as follows:
Minimum: 1 MHz
Maximum: Maximum frequency for respective clock mode specified in the CPG section
Set pins MD[2:0] to the clock mode to be used.
After powering on, wait for the CKIO clock to stabilize before performing a boundary scan
test.
another command is not re-issued from the UDI. An UDI interrupt command, however, will
be changed to a bypass command once set.
However, the TAP controller remains in operation at this time.
using an emulator.
Points for Attention
Usage Notes
Advanced User Debugger (AUD)
Rev. 5.00, 09/03, page 655 of 760