R0K561622S000BE Renesas Electronics America, R0K561622S000BE Datasheet - Page 364

• Manufacturer Part Number: R0K561622S000BE
• Description: KIT STARTER FOR H8SX/1622
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K561622S000BE

• Contents: Board, Cables, CD, Debugger, Power Supply
• Silicon Manufacturer: Renesas
• Features: Coding And Debugging, E10A Emulator, RS232 Serial Connection
• Kit Contents: Board
• Silicon Family Name: H8SX/1622F
• Silicon Core Number: R5F61622N50LGV
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: H8SX/1622
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Section 9 DMA Controller (DMAC)
Each interrupt source is specified by the interrupt enable bit in the register for the corresponding
channel. A transfer end interrupt by the transfer counter, a transfer size error interrupt, a repeat
size end interrupt, an interrupt by an extended repeat area overflow on the source address, and an
interrupt by an extended repeat area overflow on the destination address are enabled or disabled by
the DTIE bit in DMDR, the TSEIE bit in DMDR, the RPTIE bit in DACR, SARIE bit in DACR,
and the DARIE bit in DACR, respectively.
A transfer end interrupt by the transfer counter is generated when the DTIF bit in DMDR is set to
1. The DTIF bit is set to 1 when DTCR becomes 0 by a transfer while the DTIE bit in DMDR is
set to 1.
An interrupt other than the transfer end interrupt by the transfer counter is generated when the
ESIF bit in DMDR is set to 1. The ESIF bit is set to 1 when the conditions are satisfied by a
transfer while the enable bit is set to 1.
A transfer size error interrupt is generated when the next transfer cannot be performed because the
DTCR value is less than the data access size, meaning that the data access size of transfers cannot
be performed. In block transfer mode, the block size is compared with the DTCR value for
transfer error decision.
A repeat size end interrupt is generated when the next transfer is requested after completion of the
repeat size of transfers in repeat transfer mode. Even when the repeat area is not specified in the
address register, the transfer can be stopped periodically according to the repeat size. At this time,
when a transfer end interrupt by the transfer counter is generated, the ESIF bit is set to 1.
An interrupt by an extended repeat area overflow on the source and destination addresses is
generated when the address exceeds the extended repeat area (overflow). At this time, when a
transfer end interrupt by the transfer counter, the ESIF bit is set to 1.
Figure 9.39 is a block diagram of interrupts and interrupt flags. To clear an interrupt, clear the
DTIF or ESIF bit in DMDR to 0 in the interrupt handling routine or continue the transfer by
setting the DTE bit in DMDR after setting the register. Figure 9.40 shows procedure to resume the
transfer by clearing a interrupt.
Rev. 2.00 Sep. 16, 2009 Page 334 of 1036
REJ09B0414-0200