R0K561622S000BE Renesas Electronics America, R0K561622S000BE Datasheet - Page 321

• Manufacturer Part Number: R0K561622S000BE
• Description: KIT STARTER FOR H8SX/1622
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K561622S000BE

• Contents: Board, Cables, CD, Debugger, Power Supply
• Silicon Manufacturer: Renesas
• Features: Coding And Debugging, E10A Emulator, RS232 Serial Connection
• Kit Contents: Board
• Silicon Family Name: H8SX/1622F
• Silicon Core Number: R5F61622N50LGV
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: H8SX/1622
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Section 9 DMA Controller (DMAC)
(2)
Repeat Transfer Mode
In repeat transfer mode, one data access size of data is transferred at a single transfer request. Up
to 4 Gbytes can be specified as a total transfer size by DTCR. The repeat size can be specified in
DBSR up to 65536 × data access size.
The repeat area can be specified for the source or destination address side by bits ARS1 and ARS0
in DACR. The address specified as the repeat area returns to the transfer start address when the
repeat size of transfers is completed. This operation is repeated until the total transfer size
specified in DTCR is completed. When H'00000000 is specified in DTCR, it is regarded as the
free running mode and repeat transfer is continued until the DTE bit in DMDR is cleared to 0.
In addition, a DMA transfer can be stopped and a repeat size end interrupt can be requested to the
CPU or DTC when the repeat size of transfers is completed. When the next transfer is requested
after completion of a 1-repeat size data transfer while the RPTIE bit is set to 1, the DTE bit in
DMDR is cleared to 0 and the ESIF bit in DMDR is set to 1 to complete the transfer. At this time,
an interrupt is requested to the CPU or DTC when the ESIE bit in DMDR is set to 1.
The timings of the TEND and DACK signals are the same as in normal transfer mode.
Figure 9.9 shows the operation in repeat transfer mode while dual address mode is set.
When the repeat area is specified as neither source nor destination address side, the operation is
the same as the normal transfer mode operation shown in figure 9.8. In this case, a repeat size end
interrupt can also be requested to the CPU when the repeat size of transfers is completed.
Rev. 2.00 Sep. 16, 2009 Page 291 of 1036
REJ09B0414-0200