OM11077 NXP Semiconductors, OM11077 Datasheet - Page 688

• Manufacturer Part Number: OM11077
• Description: MODULE DIMM LPC2478 ARM7
• Manufacturer: NXP Semiconductors

Specifications of OM11077

• Accessory Type: Module Card
• For Use With/related Products: ARM-57TS-LPC2478
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-4742

NXP Semiconductors
UM10237_4
User manual
9.10 Blank check sector(s) <sector number> <end sector number>
9.11 Read Part Identification number
9.9 Erase sector(s) <start sector number> <end sector number>
Table 613. ISP Erase sector command
Table 614. ISP Blank check sector command
Table 615. ISP Read Part Identification command
Command
Input
Return Code CMD_SUCCESS |
Description
Example
Command
Input
Return Code CMD_SUCCESS |
Description
Example
Command
Input
Return Code CMD_SUCCESS followed by part identification number in ASCII (see
Description
E
Start Sector Number
End Sector Number: Should be greater than or equal to start sector number.
BUSY |
INVALID_SECTOR |
SECTOR_NOT_PREPARED_FOR_WRITE_OPERATION |
CMD_LOCKED |
PARAM_ERROR |
CODE_READ_PROTECTION_ENABLED
This command is used to erase one or more sector(s) of on-chip Flash memory.
The boot block can not be erased using this command. This command only allows
erasure of all user sectors when the code read protection is enabled.
"E 2 3<CR><LF>" erases the Flash sectors 2 and 3.
I
Start Sector Number:
End Sector Number: Should be greater than or equal to start sector number.
SECTOR_NOT_BLANK (followed by <Offset of the first non blank word location>
<Contents of non blank word location>) |
INVALID_SECTOR |
PARAM_ERROR |
This command is used to blank check one or more sectors of on-chip Flash
memory.
Blank check on sector 0 always fails as first 64 bytes are re-mapped to Flash
boot block.
"I 2 3<CR><LF>" blank checks the Flash sectors 2 and 3.
J
None.
“LPC24xx part Identification
This command is used to read the part identification number.
Rev. 04 — 26 August 2009
Chapter 30: LPC24XX Flash memory programming firmware
numbers”).
UM10237
© NXP B.V. 2009. All rights reserved.
Table 30–616
688 of 792