SAF-C164SM Infineon Technologies, SAF-C164SM Datasheet - Page 316

• Manufacturer Part Number: SAF-C164SM
• Description: 16-Bit CMOS Microcontroller
• Manufacturer: Infineon Technologies

Bit
BCEN
BCERR
EBCE
MPWM
User’s Manual
Function
Block Commutation Enable
0:
1:
Note: Before bit BCEN is set, all required PWM compare outputs should
Block Commutation Mode Error Flag
0:
1:
If the block commutation interrupt is enabled (EBCE = ‘1’) a CAPCOM6
emergency interrupt will also be generated.
BCERR must be cleared by software.
Enable Block Commutation Mode Error Interrupt
0:
1:
Refer to the description of bits BCERR and BCEM.
Multi-channel PWM Mode Selection
This bitfield selects the output signal pattern in all multi-channel PWM
modes (also refer to bitfield BCM).
00:
01:
10:
11:
The multi-channel PWM modes of the 16-bit capture/compare
channels (selected by bitfield MPWM) are disabled.
The multi-channel PWM modes are enabled.
No error condition.
An error condition in rotate right or rotate left mode has occurred:
- After a transition at CC6POSx all CC6POSx inputs are at high or
low level.
- A “wrong follower” condition has occurred (see description of bit
BCEM).
Block commutation mode error does not generate an interrupt.
The emergency interrupt is activated for a block commutation
mode error.
Three-phase block commutation mode.
Four-phase multi-channel PWM mode.
Five-phase multi-channel PWM mode.
Six-phase multi-channel PWM mode.
be programmed to operate as compare outputs by writing to
register CC6MSEL.
17-27
Capture/Compare Unit CAPCOM6
C164CM/C164SM
Derivatives
V1.0, 2002-02