C500CP131 Omron, C500CP131 Datasheet - Page 67

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Program View Mode
Using the PgDn and PgUp Keys
Jumping
Searching
2-14 Program View Mode
Preparations
Writing the Sheet
Positioning the Cursor
When the PgDn Key is pressed, the displayed lines move up half a page, so that
the previous bottom half of the display appears at the top of the screen and lines
previously below the screen are displayed in the bottom half of the screen. The
cursor position on the screen remains unchanged. However, if the display is
scrolled to the end of the sheet, the cursor will move to the bottom of page 2 (or
page 4, depending on the sheet size setting).
When the PgUp Key is pressed, the displayed lines move down half a page, so
that lines previously above the screen are displayed in the top half of the screen.
The cursor position on the screen remains unchanged. However, if the display is
scrolled to the start of the sheet, the cursor will move to the top of page 1.
The size of each page depends on the current sheet size setting, as follows:
The cursor position can be jumped as described for the detail view mode. See
2-8 Jumping and Searching for details.
SFC parts can be found as described for the detail view mode. See 2-8 Jumping
and Searching for details.
The program view mode allows ladder-diagram programs to be created and
edited for specified action and transition programs. This section describes the
procedure for selecting the program view mode. See Section 3 Ladder Diagram
Programming for information on programming ladder diagrams.
The sheet has to be written before changing to program view mode. If the pro-
gram view mode is selected without first writing the sheet to the disk, any
changes made to the sheet since it was last written to disk will be lost.
In the program view mode, only steps, transitions, and blanks are displayed. Be-
fore entering program view, move the cursor to a step containing at least one
action or a transition with a transition number.
16C * 100R .... 32 rows (lines) * 16 columns displayed
8C * 200R .... 32 rows * 8 columns displayed
Page
Down
Page
up
Sheet
Page 1
Section 2-14
61