C500CP131 Omron, C500CP131 Datasheet - Page 184

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Editing Network Support Tables
Error Message Table
Common Link Parameter Error Messages
Refresh Parameter Error Messages
Copying Data Link Tables
178
Comm cycle time
range err
Too many DM
words
Too many I/O words The number of I/O words exceeds the
Too many words
Begin I/O Wd range err
Begin I/O Wd set err
Begin DM Wd range err
Begin DM Wd set err
Begin status Wd range err
Begin status Wd set err
Dup node address
Node addr range err
Node addr set err
No send area
Refresh node range err
Error message
Error message
The transfer cycle time is not set to automatic
or 5 to 255.
The number of DM words exceeds 254.
prescribed range.
The total number of I/O and DM words exceeds
the prescribed range.
1, 2, 3...
The first I/O word lies outside the prescribed
range.
The data link exceeds the permissible area
range.
The first DM word lies outside the
prescribed range.
The data link exceeds the permissible link
area range.
The first status word lies outside the
prescribed range.
The status area is too small.
A node address is duplicated.
The node address is set outside the range 1
to 62.
The set node address is not set in the
common link parameters.
Link area does not exist for the node.
Number of refresh nodes lies outside the
range 2 to 62.
2. If continue is displayed at the bottom of the screen, press the PgDn Key to
1. Select “Y:Copy data link table” from the SYSMAC LINK menu.
Error description
display the next page of error messages. If errors are detected, correct the
data link table and run the check again.
Error description
Press the Home Key to set automatic
calculation or set a value in the range 5 to 255.
Set the number of DM words to below 254.
Change settings to bring the number of words
inside the prescribed range.
Change settings to bring the total number of I/O
and DM words to below 2,966 words.
Change settings to bring the first I/O word
inside the prescribed range.
Lower the first I/O word to bring the entire
link area within the prescribed range.
Change settings to bring the first DM word
inside the prescribed range.
Lower the first DM word to bring the entire
link area within the prescribed range.
Change settings to bring the first status
word inside the prescribed range.
Lower the status start word to bring the
entire status area within the prescribed
range.
Do not set the same node address twice.
Set the node address in the range 1 to 62.
Only set nodes previously set in the
common link parameters.
Set the data link words for the current node.
Check the contents of the data link table.
Remedy
Remedy
Section 4-6