C500CP131 Omron, C500CP131 Datasheet - Page 182

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Editing Network Support Tables
Editing Refresh Parameters
176
Input the communications cycle time, and input the number of I/O and DM words
for the data link to each node. Use the Up, Down, Left, Right Keys to move the
cursor to the required position on the screen.
Use one of the following methods to display a refresh parameter screen:
The data link table cannot be displayed for a disabled node. To use a node, press
the F8, node_address , and Enter Keys to enable the node before displaying the
data link table. If the F9 Key is pressed after a data link table has been created,
the contents of the table will remain unchanged but the data link will be disabled.
Com cyc time This is the time taken for the token to pass all the nodes in the data
I/O and DM # Set the number of I/O (CIO Area) and DM word used in the data
Parameter
Press the PgDn and PgUp Keys to scroll through the screens
Press the F1, node address, Enter Keys.
link. Initially dashes (-) will be displayed to indicate that the cycle
times is set automatically. This is the normal setting.
Press the Home Key twice to return the communications cycle time
to automatic calculation.
Set the cycle time to a constant value if the cycle time fluctuates
due to noise or other causes. To set a value for the transfer cycle
time, input the value in the range 5 to 255 ms and press the Enter
Key. Set the time to a value somewhat above the maximum
communications cycle time. The data link may malfunction if the
cycle time setting is too short.
link. Initially dashes (-) are displayed to indicate that there are no
I/O or DM words in the data link. If the numbers of words is set to
zero for a node, that node will not transmit data into the data link but
can access data transmitted by other node and data link status will
be refreshed.
Press the dash (-) Key to revert a set value back to the initial dash
(-).
Set the numbers of I/O and DM words in the ranges specified
below:
Only CV-series PCs in data link:
Other PCs in data link:
Restrict the total number of I/O and DM words to below 2,966
words.
I/O words 0 to 254
DM words 0 to 254
I/O words 0 to 64
DM words 0 to 254
Setting method
Section 4-6