C500CP131 Omron, C500CP131 Datasheet - Page 52

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Checking SFC Programs
2-9
Procedure
Error Messages
46
A
Level
Action # range err
Action bit # range err
Checking SFC Programs
Error Message
1, 2, 3...
The syntax of the SFC program currently being created or edited on the screen
to see if it is correct. Always check a new program or an edited program. Pro-
gram checking is carried out for the PC model designated in the PC Setup.
The time required for the program check depends on the length of the program. It
may exceed 30 seconds, in some cases. The check may take more time if the
program contains I/O names and/or I/O comments.
The errors listed in alphabetical order by check level.
or
2.
3.
1. Select “K:Check program (SFC)” from the main programming menu.
2. Select the check level from the menu. The three error check levels are de-
3. Press the Enter Key to start the program check. A message will flash on the
4. Press the Esc Key to return to the previous menu.
Press the Backspace Key to delete mistakes, then re-enter the number.
Prefixes can be designated by inputting capital letters instead of function
keys. For example, F5 may be input as Shift+T, Shift+N for an transition
number.
scribed below.
screen, and an error table will be displayed when the program check is com-
plete.
If the error table is longer than one page, use the PgDn and PgUp Keys to
switch between the pages. A message at the bottom of the screen will indi-
cate when the last page is displayed. A maximum of 400 errors (25 pages)
can be displayed. Errors exceeding this number will not be displayed.
Press the Shift+Esc Keys to return to the programming screen.
The action number is too large.
The action bit address is too large.
A
B
C
Check
level
The program is checked to see if it is executable.
The program is checked to see if there are any potential
problems in the combination of SFC parts used.
The program is checked to see if there are any potential
problems in program completeness, output timing, etc.
Description
Type of check
Check the PC model and correct
the program.
Remedy
Section 2-9