C500CP131 Omron, C500CP131 Datasheet - Page 185

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Editing Network Support Tables
Clearing Data Link Tables
Saving Data Link Tables
Retrieving Data Link Tables
1, 2, 3...
1, 2, 3...
1, 2, 3...
Note Enter the file name as up to 8 characters. Lower-case characters are converted
Be sure the data disk has been formatted and is not write-protected. Data link
table data cannot be saved if it exceeds the free space available on the data disk.
to upper-case. A single directory name can have up to 8 characters with a total of
66 characters for the entire path name. See 6-2 File Management for more infor-
mation about directories.
2. Enter the copy source node address in the range 1 to 62 and press the Enter
3. Press the Enter Key to display the screen to set the copy destination.
4. Move the cursor to the copy destination nodes and press the Enter Key.
5. Select “J :Run.”
1. Select “C:Clear data link table” from the SYSMAC LINK menu.
2. Press the Y and Enter Keys to clear the contents of the data link table and
1. Select “S:Save data link table” from the SYSMAC LINK menu. A file name
2. Enter the file name and press the Enter Key.
3. If the input file name already exists, a message will ask if the file should be
4. Input the title and press the Enter Key. The title can be up to 30 characters
1. Select “L:Retrieve data link table” from the SYSMAC LINK menu. A file
Key. Nodes that are disabled cannot be set.
Yes will be displayed to indicate nodes that have been set as a copy destina-
tions. Multiple nodes can be set.
To deselect a node as a copy destination, move the cursor to the node and
press the Enter Key again.
The copy source node will be copied to the destination nodes, and all pre-
vious data will be cleared from the copy destination nodes.
Disabled copy destination nodes will be enabled after the copy is complete.
The common link parameter screen will be displayed when the copy is com-
plete.
enable only nodes 1 and 2 enabled (all others nodes will be disabled).
input area will be displayed.
To enter an existing file name, press the End Key or Ctrl+M Keys to display
the current file names, select the required file name with the cursor, and
press the Enter Key.
overwritten.Press the Y and Enter Keys to overwrite the file. Press the Enter
Key to cancel and input a new file name.
The title input area will appear when the Enter Key is pressed.
long.
A message will flash while the table is being saved. The data link table will be
displayed after the data is saved.
name input area will be displayed.
Section 4-6
179