C500CP131 Omron, C500CP131 Datasheet - Page 207

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Initialization
6-1
Procedure
202
Initialization
1, 2, 3...
Note For installation purposes, copy your computer’s format command to the CVSS
Note This operation uses the FORMAT command in MS-DOS and must therefore be
The following operations can be used to format a floppy disk to enable it to store
data. Use 3.5-inch (2HD or 2 DD) or 5.25-inch (2HD or 2D) floppy disks. The
storage capacity of floppy disks after initialization will be approximately 1.44M
bytes for 3.5-inch 2 HD, 720K bytes for 3.5-inch 2DD, 1.2M bytes for 5.25-inch
2HD, and 360K bytes for 5.25-inch 2D floppy disks.
All existing data is cleared from a floppy disk during initialization.
directory.
executed only where the FORMAT command is accessible and supported (e.g.,
the FORMAT command must be in the CVSS directory).
The following FORMAT commands can be used depending on the computer,
floppy disk type, and disk storage capacity.
PS/2 (Ver 4.0)
PS/2 (Ver 3.30)
COMPAQ (Ver 4.0)
1. Select “M:Format floppy” from the main offline menu with the cursor.
2. Insert a floppy disk into the drive. Be sure the disk is not write-protected.
3. Press the Y and Enter Keys in response to the confirmation message to for-
4. Specify the drive and floppy disk size. Press the Enter Key. Format the
5. After formatting is complete, a message will ask the operator to press any
6. To format another floppy disk, replace the floppy disk in the drive and repeat
7. When finished formatting, press the Esc Key or Shift+Esc Keys to return to
[ Formatting ]
Format floppy disk?
Warning:
Are you sure you want to format?(Y/N)
mat the floppy disk.
[ Format command ]
Input the drive number and disk media parameter.
Format
floppy disks with the parameters as shown in the following table.
It takes 1 to 2 minutes from the time the progress display appears to format a
floppy disk.
Formatting cannot be stopped once it has been started.
key. Press the Enter Key to return to the drive selection display.
the procedure above from setup 3.
the main offline menu.
Model
Format will erase all data on the disk.
Do not format the Hard Disk.
Drive
5.25”
5.25”
5.25”
3.5”
3.5”
3.5”
Disk storage
(K bytes)
1,440
1,200
1,440
1,200
1,440
1,200
720
720
720
FORMAT A:
FORMAT A:/N:9 /T:80
FORMAT A:
FORMAT A:
FORMAT A:/N:9 /T:80
FORMAT A:
FORMAT A:
FORMAT A:/N:9 /T:80
FORMAT A:
Command
Section 6-1