C500CP131 Omron, C500CP131 Datasheet - Page 125

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Checking the Program
Scrolling
3-11 Checking the Program
1, 2, 3...
Press the PgDn or PgUp Keys to display the page after or before the current
page.
The following operations are used to check to see if the ladder program on the
work disk is correct. These operations can be used regardless of whether the
program was written in ladder or mnemonic form.
Always use the check operation to check a newly created or edited ladder pro-
gram after storing the program on the work disk.
or
PgDn
PgUp
1. Select “K:Check program” from the main programming menu and then
2. Select the check level.
Press the Enter Key to start searching from program address 00000. During
the operation, a message will flash at the top-right of the screen.
When the specified input, instruction, or operand is found, 20 lines of the mne-
monic program will be displayed beginning with the instruction that was found.
Press the Enter Key to repeat the search.
Press the Esc Key followed by the Tab Key to display the previously found in-
struction.
Press the PgDn or PgUp Keys to display the page before or after the currently
displayed page.
Press the Esc Key to cancel the operation.
specify the programs to be checked on the following display.
A: All actions and transitions
Check all ladder and mnemonic programs on the work disk.
B: Current actions and transitions
Check only the ladder or mnemonic program displayed on the screen.
If the program type is set to Ladder, the following display will not appear and
the menu to set the check levels will appear.
When the check level is selected, the program check will start and a mes-
sage will flash on the display.
A
B
C
Error level
Key
Error that prevent execution or result in NOPs
Warnings, i.e, non-fatal errors
Parts left out of the program or output timing errors
Read the next page.
Read the previous page.
Description
Description
Section 3-11
119