MC9S12P32CFT Freescale Semiconductor, MC9S12P32CFT Datasheet - Page 465

• Manufacturer Part Number: MC9S12P32CFT
• Description: MCU 16BIT 32K FLASH 48-QFN
• Manufacturer: Freescale Semiconductor
• Series: HCS12r

Specifications of MC9S12P32CFT

• Core Processor: HCS12
• Core Size: 16-Bit
• Speed: 32MHz
• Connectivity: CAN, SCI, SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 34
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 4K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 1.72 V ~ 5.5 V
• Data Converters: A/D 10x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-QFN Exposed Pad
• Processor Series: S12P
• Core: HCS12
• 3rd Party Development Tools: EWHCS12
• Development Tools By Supplier: KIT33812ECUEVME, DEMO9S12PFAME
• Package: 48QFN EP
• Family Name: HCS12
• Maximum Speed: 32 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 16 Bit
• Interface Type: CAN/SCI/SPI
• On-chip Adc: 10-chx12-bit
• Number Of Timers: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

13.4.5.13 Set Field Margin Level Command
The Set Field Margin Level command, valid in special modes only, causes the Memory Controller to set
the margin level specified for future read operations of the P-Flash or D-Flash block.
Upon clearing CCIF to launch the Set Field Margin Level command, the Memory Controller will set the
field margin level for the targeted block and then set the CCIF flag.
Valid margin level settings for the Set Field Margin Level command are defined in
Freescale Semiconductor
Register
FSTAT
User margin levels can be used to check that Flash memory contents have
adequate margin for normal level read operations. If unexpected results are
encountered when checking Flash memory contents at user margin levels, a
potential loss of information has been detected.
CCOBIX[2:0]
When the D-Flash block is targeted, the D-Flash field margin levels are
applied only to the D-Flash reads. However, when the P-Flash block is
targeted, the P-Flash field margin levels are applied to both P-Flash and D-
Flash reads. It is not possible to apply field margin levels to the P-Flash
block only.
Table 13-56. Set Field Margin Level Command FCCOB Requirements
000
001
MGSTAT1
MGSTAT0
ACCERR
Table 13-55. Set User Margin Level Command Error Handling
Error Bit
FPVIOL
S12P-Family Reference Manual, Rev. 1.13
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see
Set if an invalid global address [17:16] is supplied
Set if an invalid margin level setting is supplied
None
None
None
0x0E
NOTE
NOTE
FCCOB Parameters
Margin level setting
Global address [17:16] to identify the Flash
Error Condition
128 KByte Flash Module (S12FTMRC128K1V1)
block
Table
13-27)
Table
13-57.
465