DF2328BVF25V Renesas Electronics America, DF2328BVF25V Datasheet - Page 674

• Manufacturer Part Number: DF2328BVF25V
• Description: IC H8S MCU FLASH 256K 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2328BVF25V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: EDK2329 - DEV EVALUATION KIT H8S/2329
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: HD64F2328BVF25V

Section 14 Serial Communication Interface (SCI)
In serial transmission, the SCI operates as described below.
[1] The SCI monitors the TDRE flag in SSR, and if is 0, recognizes that data has been written to
[2] After transferring data from TDR to TSR, the SCI sets the TDRE flag to 1 and starts
[3] The SCI checks the TDRE flag at the timing for sending the stop bit.
Rev.6.00 Sep. 27, 2007 Page 642 of 1268
REJ09B0220-0600
TDR, and transfers the data from TDR to TSR.
transmission.
If the TIE bit is set to 1 at this time, a transmit-data-empty interrupt (TXI) is generated.
The serial transmit data is sent from the TxD pin in the following order.
[a] Start bit:
[b] Transmit data:
[c] Multiprocessor bit
[d] Stop bit(s):
[e] Mark state:
If the TDRE flag is cleared to 0, data is transferred from TDR to TSR, the stop bit is sent, and
then serial transmission of the next frame is started.
If the TDRE flag is set to 1, the TEND flag in SSR is set to 1, the stop bit is sent, and then the
mark state is entered in which 1 is output continuously. If the TEIE bit in SCR is set to 1 at this
time, a transmit-end interrupt (TEI) request is generated.
One 0-bit is output.
8-bit or 7-bit data is output in LSB-first order.
One multiprocessor bit (MPBT value) is output.
One or two 1-bits (stop bits) are output.
1 is output continuously until the start bit that starts the next transmission is sent.