DF2328BVF25V Renesas Electronics America, DF2328BVF25V Datasheet - Page 296

• Manufacturer Part Number: DF2328BVF25V
• Description: IC H8S MCU FLASH 256K 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2328BVF25V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: EDK2329 - DEV EVALUATION KIT H8S/2329
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: HD64F2328BVF25V

Section 7 DMA Controller (Not Supported in the H8S/2321)
MAR specifies the start address of the transfer source or transfer destination as 24 bits. MAR is
incremented or decremented by 1 or 2 each time a byte or word is transferred.
IOAR specifies the lower 16 bits of the other address. The 8 bits above IOAR have a value of
H'FF.
The number of transfers is specified as 8 bits by ETCRH and ETCRL. The maximum number of
transfers, when H'00 is set in both ETCRH and ETCRL, is 256.
In repeat mode, ETCRL functions as the transfer counter, and ETCRH is used to hold the number
of transfers. ETCRL is decremented by 1 each time a transfer is executed, and when its value
reaches H'00, it is loaded with the value in ETCRH. At the same time, the value set in MAR is
restored in accordance with the values of the DTSZ and DTID bits in DMACR. The MAR
restoration operation is as shown below.
DTID
DTSZ
MAR = MAR – (–1)
· 2
· ETCRH
The same value should be set in ETCRH and ETCRL.
In repeat mode, operation continues until the DTE bit is cleared. To end the transfer operation,
therefore, the DTE bit should be cleared to 0. A transfer end interrupt request is not sent to the
CPU or DTC.
By setting the DTE bit to 1 again after it has been cleared, the operation can be restarted from the
transfer after that terminated when the DTE bit was cleared.
Rev.6.00 Sep. 27, 2007 Page 264 of 1268
REJ09B0220-0600