HD6412240 RENESAS [Renesas Technology Corp], HD6412240 Datasheet - Page 246

• Manufacturer Part Number: HD6412240
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family / H8S/2200 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 7 Data Transfer Controller
7.3.12
(1) Normal Mode
The first example shows how the DTC can be used to receive 128 bytes of data via the SCI.
[1] Set MRA to fixed source address (SM1 = SM0 = 0), incrementing destination address (DM1 =
[2] Set the start address of the register information at the DTC vector address.
[3] Set the corresponding bit in DTCER to 1.
[4] Set the SCI to the appropriate receive mode. Set the RIE bit in SCR to 1 to enable the reception
[5] Each time reception of one byte of data ends on the SCI, the RDRF flag in SSR is set to 1, an
[6] When CRA becomes 0 after the 128 data transfers have ended, the RDRF flag is held at 1, the
Rev.3.00 Mar. 26, 2007 Page 204 of 772
REJ09B0355-0300
1, DM0 = 0), normal mode (MD1 = MD0 = 0), and byte size (Sz = 0). The DTS bit can have
any value. Set MRB for one data transfer by one interrupt (CHNE = 0, DISEL = 0). Set the
SCI RDR address in SAR, the start address of the RAM area where the data will be received in
DAR, and 128 (H'0080) in CRA. CRB can be set to any value.
complete (RXI) interrupt. Since the generation of a receive error during the SCI reception
operation will disable subsequent reception, the CPU should be enabled to accept receive error
interrupts.
RXI interrupt is generated, and the DTC is activated. The receive data is transferred from RDR
to RAM by the DTC, and then DAR is incremented and CRA is decremented. The RDRF flag
is automatically cleared to 0.
DTCE bit is cleared to 0, and an RXI interrupt request is sent to the CPU. The interrupt
handling routine should perform wrap-up processing.
Examples of Use of the DTC