HD6412240 RENESAS [Renesas Technology Corp], HD6412240 Datasheet - Page 153

• Manufacturer Part Number: HD6412240
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family / H8S/2200 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

5.3
Interrupt sources comprise external interrupts (NMI and IRQ7 to IRQ0) and internal interrupts (34
sources).
5.3.1
There are nine external interrupts: NMI and IRQ7 to IRQ0. Of these, NMI and IRQ2 to IRQ0 can
be used to restore the H8S/2245 Group from software standby mode.
NMI Interrupt: NMI is the highest-priority interrupt, and is always accepted by the CPU
regardless of the status of the CPU interrupt mask bits. The NMIEG bit in SYSCR can be used to
select whether an interrupt is requested at a rising edge or a falling edge on the NMI pin.
The vector number for NMI interrupt exception handling is 7.
IRQ7 to IRQ0 Interrupts: Interrupts IRQ7 to IRQ0 are requested by an input signal at pins IRQ7
to IRQ0. Interrupts IRQ7 to IRQ0 have the following features:
A block diagram of interrupts IRQ7 to IRQ0 is shown in figure 5.2.
Figure 5.3 shows the timing of setting IRQnF.
Using ISCR, it is possible to select whether an interrupt is generated by a low level, falling
edge, rising edge, or both edges, at pins IRQ7 to IRQ0.
Enabling or disabling of interrupt requests IRQ7 to IRQ0 can be selected with IER.
The interrupt control level can be set with ICR.
The status of interrupt requests IRQ7 to IRQ0 is indicated in ISR. ISR flags can be cleared to 0
by software.
IRQn input
Note: n = 7 to 0
Interrupt Sources
External Interrupts
Figure 5.2 Block Diagram of Interrupts IRQ7 to IRQ0
IRQnSCA, IRQnSCB
detection circuit
Edge/level
Clear signal
S
R
IRQnF
Rev.3.00 Mar. 26, 2007 Page 111 of 772
Q
IRQnE
Section 5 Interrupt Controller
IRQn interrupt
request
REJ09B0355-0300