IPR-PCI/MT32 Altera, IPR-PCI/MT32 Datasheet - Page 59

• Manufacturer Part Number: IPR-PCI/MT32
• Description: IP CORE Renewal Of IP-PCI/MT32
• Manufacturer: Altera
• Type: MegaCorer

Specifications of IPR-PCI/MT32

• Software Application: IP CORE, Interface And Protocols, PCI
• Supported Families: Arria GX, Arria II GX, Cyclone, Stratix
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Rohs Compliant: NA
• Function: PCI Compiler, Master/Target, 32 bit
• License: Renewal License
• Lead Free Status / RoHS Status: na
• Lead Free Status / RoHS Status: na

Parameterize
PCI Compiler
PCI MegaCore
Function
Settings
Altera Corporation
January 2011
This chapter describes the parameters available to configure PCI
Compiler, including:
■
■
■
■
■
You can customize the PCI MegaCore functions by changing parameters
and specifying optional features using the Parameterize - PCI Compiler
wizard. Start the wizard by clicking Step 1: Parameterize in IP
Toolbench.
These parameters allow you to customize the PCI MegaCore functions to
meet specific application requirements, such as defining read-only and
read/write PCI configuration space. The wizard is also used to enable
and parameterize optional features.
For a complete list of parameter names and descriptions found in a
generated PCI MegaCore function variation file, refer to
Parameters” on page
The PCI MegaCore functions are capable of operating at clock speeds of
up to 66 MHz. Depending on the PCI device speed, the PCI 66-MHz
Capable option is enabled or disabled on the PCI MegaCore Function
Settings page of the Parameterize - PCI Compiler wizard.
When turned on, the PCI 66-MHz Capable option sets bit 5 of the PCI
configuration space status register. For more information on the function
of this register, refer to
“PCI MegaCore Function Settings”
“Read-Only PCI Configuration Registers”
“PCI Base Address Registers (BARs)”
“Advanced PCI MegaCore Function Features”
“Variation File Parameters”
PCI Compiler Version 10.1
2–7.
“Configuration Registers” on page
2. Parameter Settings
“Variation File
3–28.
2–1