TMPM370FYFG Toshiba, TMPM370FYFG Datasheet - Page 94

• Manufacturer Part Number: TMPM370FYFG
• Manufacturer: Toshiba

Specifications of TMPM370FYFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 256K
• Rom Type: Flash
• Ram (kbytes): 10K
• Number Of Pins: 100
• Package: LQFP(14x14)
• Vcc: 5V
• Cpu Mhz: 80
• Ssp (ch) Spi: -
• I2c/sio (ch): -
• Uart/sio (ch): 4
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 27
• 16-bit Timer / Counter: 8
• Motor / Igbt Control: Vector Engine
• Real Time Clock: -
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: -
• Hardware Cec Controller: -
• Comparators: 4
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

Be sure to set active state of the Standby clear request, in case the interrupt is enabled for clearing the
Standby modes.
(Note 1) When using interrupts, be sure to follow the sequence of actions shown below:
(Note 2) Each settings must be performed while interrupts are disabled.
(Note 3) For clearing the Standby modes , 16 interrupt factors (INT0 to INTF) are available. CGIMCGA to
(Note 4) In case the standby mode clear is not required, INT0 to INTF can be used as a normal interrupt
CGIMCGD Resisters in CG are used for selecting edge/level of active state and which
aforementioned factors are used for clearing the standby modes.
without setting CGIMCGA to CGIMCGD Resisters in CG.
1) If the external intrrupt request pin shared with other general ports, enable the port to receive the
interrupt.
2) Set conditions such as active state upon initialization.
3) Clear interrupt requests.
4) Enable interrupts.
TMPM370 7-56
TMPM370
Interrupt