SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 829

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

43.5.5
43.6
43.6.1
6289D–ATARM–3-Oct-11
Touch Screen
Sample and Hold Time
Resistive Touch Screen Principles
Mode
conversion of the sequence.
The field STARTUP can define a Startup Time between 8 and 1024 ADC Clock cycles by steps
of 8.
The user must assure that ADC Startup Time given in the section “Electrical Characteristics” is
covered by this wait time.
In the same way, a minimal Sample and Hold Time is necessary for the TSADCC to guarantee
the best converted final value between selection of two channels. This time depends on the input
impedance of the analog input, but also on the output impedance of the driver providing the sig-
nal to the analog input, as there is no input buffer amplifier.
The Sample and Hold time has to be programmed through the bitfields SHTIM in the
Mode Register”
The field SHTIM defines the number of ADC Clock cycles for an analog input, while the field
TSSHTIM defines the number of ADC Clock cycles for a Touch Screen input.
These both fields can define a Sample and Hold time between 1 and 16 ADC Clock cycles.
The field TSSHTIM defines also the time the power switches of the Touch Screen are closed
when the TSADCC performs a conversion for the Touch Screen.
A resistive touch screen is based on two resistive films, each one being fitted with a pair of elec-
trodes, placed at the top and bottom on one film, and on the right and left on the other. Between
the two, there is a layer that acts as an insulator, but also enables contact when you press the
screen. This is illustrated in
Register”, which defines how many ADC Clock cycles to wait before performing the first
and TSSHTIM in the
Figure
43-2.
“TSADCC Touch Screen
AT91SAM9R64/RL64
Register”.
“TSADCC
829