SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 753

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

41.4.8.15
Figure 41-15. Stall Handshake Data OUT Transfer
Figure 41-16. Stall Handshake Data IN Transfer
6289D–ATARM–3-Oct-11
STALL
USB Bus
Packets
FRCESTALL
STALL_SNT
USB Bus
Packets
FRCESTALL
STALL_SNT
STALL is returned by a function in response to an IN token or after the data phase of an OUT or
in response to a PING transaction. STALL indicates that a function is unable to transmit or
receive data, or that a control pipe request is not supported.
To stall an endpoint, set the FRCESTALL bit in UDPHS_EPTSETSTAx register and after the
STALL_SNT flag has been set, set the TOGGLE_SEG bit in the UDPHS_EPTCLRSTAx
register.
Set the FRCESTALL bit in UDPHS_EPTSETSTAx register.
• OUT
• IN
Token OUT
Set by Firmware
Token IN
Set by Firmware
Data OUT
Set by Hardware
Set by Hardware
Stall PID
Stall PID
Interrupt Pending
Interrupt Pending
Cleared by Firmware
AT91SAM9R64/RL64
Cleared by Firmware
Cleared by Firmware
Cleared by Firmware
753