YLCDRSK2378 Renesas Electronics America, YLCDRSK2378 Datasheet - Page 424

• Manufacturer Part Number: YLCDRSK2378
• Description: KIT DEV EVAL H8S/2378 LCD
• Manufacturer: Renesas Electronics America
• Series: H8®r

Specifications of YLCDRSK2378

• Main Purpose: Displays, LCD Controller
• Embedded: Yes, MCU, 16-Bit
• Utilized Ic / Part: YLCDRSK2378
• Primary Attributes: 5.7" QVGA, Touch Screen
• Secondary Attributes: Source Code on CD, Debugging Requires Emulator Cable E10A USB/JTAG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Section 7 DMA Controller (DMAC)
7.7.3
When the WDBE bit of BCR in the bus controller is set to 1, enabling the write data buffer
function, dual address transfer external write cycles or single address transfers and internal
accesses (on-chip memory or internal I/O registers) are executed in parallel.
• Write data buffer function and DMAC register setting
• Write data buffer function and DMAC operation timing
7.7.4
If the last transfer cycle is for an internal address, note that even if low-level output at the TEND
pin has been set, a low level may not be output at the TEND pin under the following external bus
conditions since the last transfer cycle (internal bus cycle) and the external bus cycle are executed
in parallel.
1. EXDMAC cycle
2. Write cycle with write buffer mode enabled
3. DMAC single address cycle for a different channel with write buffer mode enabled
4. Bus release cycle
5. CBR refresh cycle
Figure 7.41 shows an example in which a low level is not output from the TEND pin in case 2
above.
If the last transfer cycle is an external address cycle, a low level is output at the TEND pin in
synchronization with the bus cycle.
Rev.7.00 Mar. 18, 2009 page 356 of 1136
REJ09B0109-0700
If the setting of a register that controls external accesses is changed during execution of an
external access by means of the write data buffer function, the external access may not be
performed normally. Registers that control external accesses should only be manipulated when
external reads, etc., are used with DMAC operation disabled, and the operation is not
performed in parallel with external access.
The DMAC can start its next operation during external access using the write data buffer
function. Consequently, the DREQ pin sampling timing, TEND output timing, etc., are
different from the case in which the write data buffer function is disabled. Also, internal bus
cycles maybe hidden, and not visible.
Write Data Buffer Function
TEND Output