DF2367VF33 Renesas Electronics America, DF2367VF33 Datasheet - Page 233

• Manufacturer Part Number: DF2367VF33
• Description: MCU 3V 384K 128-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2367VF33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2367VF33; HD64F2367VF33

Section 6 Bus Controller (BSC)
6.6.9
Wait Control
There are two ways of inserting wait states in a DRAM access cycle: program wait insertion and
pin wait insertion using the WAIT pin.
Wait states are inserted to extend the CAS assertion period in a read access to DRAM space, and
to extend the write data setup time relative to the falling edge of CAS in a write access.
Program Wait Insertion: When the bit in ASTCR corresponding to an area designated as DRAM
space is set to 1, from 0 to 7 wait states can be inserted automatically between the T
state and T
c1
c2
state, according to the WTCR setting.
Pin Wait Insertion: When the WAITE bit in BCR is set to 1 and the ASTCR bit is set to 1, wait
input by means of the WAIT pin is enabled. When DRAM space is accessed in this state, a
) is first inserted. If the WAIT pin is low at the falling edge of φ in the last T
program wait (T
or
w
c1
state is inserted. If the WAIT pin is held low, T
T
state, another T
states are inserted until it
w
w
w
goes high.
Figures 6.25 and 6.26 show examples of wait cycle insertion timing in the case of 2-state and 3-
state column address output cycles.
Rev.6.00 Mar. 18, 2009 Page 173 of 980
REJ09B0050-0600