ATMEGA8HVD-4MX Atmel, ATMEGA8HVD-4MX Datasheet - Page 64

• Manufacturer Part Number: ATMEGA8HVD-4MX
• Description: MCU AVR 8K FLASH 2.1-8V 4MHZ QFN
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA8HVD-4MX

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 4MHz
• Peripherals: POR, WDT
• Number Of I /o: 5
• Program Memory Size: 8KB (4K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 2.4 V
• Data Converters: A/D 1x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 18-MLF® Exposed Pad (Staggered Leads), DFN
• For Use With: ATSTK600 - DEV KIT FOR AVR/AVR32ATSTK500 - PROGRAMMER AVR STARTER KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Connectivity: -

64
ATmega4HVD/8HVD
Figure 14-3. Synchronization when Reading an Externally Applied Pin value
Consider the clock period starting shortly after the first falling edge of the system clock. The
latch is closed when the clock is low, and goes transparent when the clock is high, as indi-
cated by the shaded region of the “SYNC LATCH” signal. The signal value is latched when the
system clock goes low. It is clocked into the PINxn Register at the succeeding positive clock
edge. As indicated by the two arrows tpd,max and tpd,min, a single signal transition on the pin
will be delayed between ½ and 1½ system clock period depending upon the time of assertion.
When reading back a software assigned pin value, a nop instruction must be inserted as indi-
cated in
the clock. In this case, the delay tpd through the synchronizer is 1 system clock period.
Figure 14-4. Synchronization when Reading a Software Assigned Pin Value
The following code example shows how to set port B pins 0 and 1 high, 2 and 3 low, and
define the port pins from 4 to 7 as input with pull-ups assigned to port pins 6 and 7. The result-
ing pin values are read back again, but as previously discussed, a nop instruction is included
to be able to read back the value recently assigned to some of the pins.
INSTRUCTIONS
INSTRUCTIONS
Figure
SYSTEM CLK
SYNC LATCH
SYSTEM CLK
SYNC LATCH
14-4. The out instruction sets the “SYNC LATCH” signal at the positive edge of
PINxn
PINxn
r17
r16
r17
out PORTx, r16
XXX
t
pd, max
0x00
0x00
nop
XXX
t
pd
0xFF
t
pd, min
in r17, PINx
in r17, PINx
0xFF
0xFF
8052B–AVR–09/08