DF2266TF13V Renesas Electronics America, DF2266TF13V Datasheet - Page 428

• Manufacturer Part Number: DF2266TF13V
• Description: IC H8S/2266 MCU FLASH 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of DF2266TF13V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 13MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: LCD, POR, PWM, WDT
• Number Of I /o: 67
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 10x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 13 Serial Communication Interface (SCI)
Table 13.13 Interrupt Sources in Smart Card Interface Mode
Notes: 1. Indicates the initial state immediately after a reset.
13.9
13.9.1
SCI operation can be disabled or enabled using the module stop control register. The initial setting
is for SCI operation to be halted. Register access is enabled by clearing module stop mode. For
details, refer to section 22, Power-Down Modes.
13.9.2
When framing error (FER) detection is performed, a break can be detected by reading the RxD pin
value directly. In a break, the input from the RxD pin becomes all 0s, setting the FER flag, and
possibly the PER flag. Note that as the SCI continues the receive operation after receiving a break,
even if the FER flag is cleared to 0, it will be set to 1 again.
13.9.3
When TE is 0, the TxD pin is used as an I/O port whose direction (input or output) and level are
determined by DDR. This can be used to set the TxD pin to mark state (high level) or send a break
during serial data transmission. To maintain the communication line at mark state until TE is set to
1, set both DDR and DR to 1. As TE is cleared to 0 at this point, the TxD pin becomes an I/O port,
Rev. 5.00 Sep. 01, 2009 Page 376 of 656
REJ09B0071-0500
Channel
0
1
2
2. Supported only by the H8S/2268 Group.
Usage Notes
Module Stop Mode Setting
Break Detection and Processing (Asynchronous Mode Only)
Mark State and Break Detection (Asynchronous Mode Only)
Priorities in channels can be changed by the interrupt controller. (H8S/2268 Group only)
Name
ERI0
RXI0
TXI0
ERI1
RXI1
TXI1
ERI2
RXI2
TXI2
Interrupt Source
Receive Error, detection
Receive Data Full
Transmit Data Empty
Receive Error, detection
Receive Data Full
Transmit Data Empty
Receive Error, detection
Receive Data Full
Transmit Data Empty
Interrupt Flag
ORER, PER, ERS
RDRF
TEND
ORER, PER, ERS
RDRF
TEND
ORER, PER, ERS
RDRF
TEND
DTC
Activation *
Not possible
Possible
Possible
Not possible
Possible
Possible
Not possible
Possible
Possible
2
Priority *
High
Low
1