ATAVRSB202 Atmel, ATAVRSB202 Datasheet - Page 19

• Manufacturer Part Number: ATAVRSB202
• Description: KIT BATT MGMT FOR ATMEGA32HVB
• Manufacturer: Atmel

Specifications of ATAVRSB202

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: *
• Primary Attributes: *
• Secondary Attributes: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8.4
8.4.1
8.5
8042B–AVR–06/10
EEPROM Data Memory
I/O Memory
EEPROM Read/Write Access
Figure 8-3.
The ATmega16HVB/32HVB contains 512/1K bytes of data EEPROM memory. It is organized as
a separate data space, in which single bytes can be read and written. The EEPROM has an
endurance of at least 100,000 write/erase cycles. The access between the EEPROM and the
CPU is described in the following, specifying the EEPROM Address Registers, the EEPROM
Data Register, and the EEPROM Control Register.
For a detailed description of EEPROM programming, see
The EEPROM Access Registers are accessible in the I/O space.
The write access time for the EEPROM is given in
however, lets the user software detect when the next byte can be written. If the user code con-
tains instructions that write the EEPROM, some precautions must be taken.
In order to prevent unintentional EEPROM writes, a specific write procedure must be followed.
Refer to the description of the EEPROM Control Register for details on this.
When the EEPROM is read, the CPU is halted for four clock cycles before the next instruction is
executed. When the EEPROM is written, the CPU is halted for two clock cycles before the next
instruction is executed.
The I/O space definition of the ATmega16HVB/32HVB is shown in
256.
All ATmega16HVB/32HVB I/Os and peripherals are placed in the I/O space. All I/O locations
may be accessed by the LD/LDS/LDD and ST/STS/STD instructions, transferring data between
the 32 general purpose working registers and the I/O space. I/O Registers within the address
range 0x00 - 0x1F are directly bit-accessible using the SBI and CBI instructions. In these regis-
ters, the value of single bits can be checked by using the SBIS and SBIC instructions. Refer to
the instruction set section for more details. When using the I/O specific commands IN and OUT,
Address
clk
On-chip Data SRAM Access Cycles
Data
Data
WR
CPU
RD
Compute Address
T1
Memory Access Instruction
Address valid
Table 8-1 on page
T2
ATmega16HVB/32HVB
page 211
Next Instruction
”Register Summary” on page
and
T3
21. A self-timing function,
page 216
respectively.
19