EVB9311 SMSC, EVB9311 Datasheet - Page 273

• Manufacturer Part Number: EVB9311
• Description: EVALUATION BOARD LAN9311-NU
• Manufacturer: SMSC
• Series: 0133r

Specifications of EVB9311

• Main Purpose: Interface, Ethernet
• Embedded: No
• Utilized Ic / Part: LAN9311
• Primary Attributes: 2 Ports, 100BASE-TX/10BASE-T, Managed
• Secondary Attributes: 2 PHYs with HP Auto-MDIX, Auto- Flow Control, 32-bit CRC, MDI/MDI-X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 638-1076

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9311/LAN9311i
BITS
16
15
14
13
12
11
10
9
8
Pass Bad Frames (PASSBAD)
When set, all incoming frames that passed address filtering are received,
including runt frames and collided frames. Refer to
Filtering," on page 115
Hash Only Filtering mode (HO)
When set, the address check Function operates in the Imperfect address
filtering mode for both physical and multicast addresses. Refer to
9.4.2, "Hash Only Filtering," on page 116
RESERVED
Hash/Perfect Filtering Mode (HPFILT)
When cleared (0), the LAN9311/LAN9311i will implement a perfect address
filter on incoming frames according the address specified in the Host MAC
address registers
Host MAC Address Low Register
When set (1), the address check function performs imperfect address
filtering of multicast incoming frames according to the hash table specified
in the multicast hash table register. If the Hash Only Filtering mode (HO) bit
15 is set, then the physical (IA) addresses are also imperfect filtered. If the
Hash Only Filtering mode (HO) bit is cleared, then the IA addresses are
perfect address filtered according to the MAC Address register Refer to
Section 9.4.3, "Hash Perfect Filtering," on page 116
information.
RESERVED
Disable Broadcast Frames (BCAST)
When set, disables the reception of broadcast frames. When cleared,
forwards all broadcast frames to the application.
Note:
Disable Retry (DISRTY)
When set, the Host MAC attempts only one transmission. When a collision
is seen on the bus, the Host MAC ignores the current frame and goes to the
next frame and a retry error is reported in the Transmit status. When reset,
the Host MAC attempts 16 transmissions before signaling a retry error.
RESERVED
Automatic Pad Stripping (PADSTR)
When set, the Host MAC strips the pad field on all incoming frames, if the
length field is less than 46 bytes. The FCS field is also stripped, since it is
computed at the transmitting station based on the data and pad field
characters, and is invalid for a received frame that has had the pad
characters stripped. Receive frames with a 46-byte or greater length field
are passed to the application unmodified (FCS is not stripped). When
cleared, the Host MAC passes all incoming frames to the host unmodified.
When wake-up frame detection is enabled via the WUEN bit of the
Host MAC Wake-up Control and Status Register
a broadcast wake-up frame will wake-up the device despite the
state of this bit.
(Host MAC Address High Register (HMAC_ADDRH)
for additional information.
DESCRIPTION
(HMAC_ADDRL)).
DATASHEET
for additional information.
273
Section 9.4, "Address
for additional
(HMAC_WUCSR),
Section
and
TYPE
R/W
R/W
R/W
R/W
R/W
R/W
RO
RO
RO
Revision 1.7 (06-29-10)
DEFAULT
0b
0b
0b
0b
0b
0b
-
-
-