r5s72060w200fpv Renesas Electronics Corporation., r5s72060w200fpv Datasheet - Page 405

• Manufacturer Part Number: r5s72060w200fpv
• Description: 32-bit Risc Microcomputer Superhtm Risc Engine Family / Sh7200 Series
• Manufacturer: Renesas Electronics Corporation.

Note:
If the priority mode bits are modified after a DMA transfer, the channel priority is initialized. If
fixed mode 2 is specified, the channel priority is specified as CH0 > CH4 > CH1 > CH5 > CH2 >
CH6 > CH3 > CH7. If fixed mode 1 is specified, the channel priority is specified as CH0 > CH1 >
CH2 > CH3 > CH4 > CH5 > CH6 > CH7. If the round-robin mode is specified, the transfer end
channel is reset.
Table 9.3 show the priority change in each mode (modes 0 to 2) specified by the priority mode
bits. In each priority mode, the channel priority to accept the next transfer request may change in
up to three ways according to the transfer end channel.
For example, when the transfer end channel is channel 1, the priority of the channel to accept the
next transfer request is specified as CH2 > CH3 > CH0 >CH1 > CH4 > CH5 > CH6 > CH7. When
the transfer end channel is any one of the channels 4 to 7, round-robin will not be applied and the
priority level is not changed at the end of transfer in the channels 4 to 7.
The DMAC internal operation for an address error is as follows:
• No address error: Read (source to DMAC) → Write (DMAC to destination)
• Address error in source address: Nop → Nop
• Address error in destination address: Read → Nop
Bit
0
*
Bit Name
DME
Only 0 can be written to clear the flag after 1 is read.
Initial
Value
0
R/W
R/W
Description
DMA Master Enable
Enables or disables DMA transfer on all channels. If
the DME bit and DE bit in CHCR are set to 1, DMA
transfer is enabled.
However, transfer is enabled only when the TE bit in
CHCR of the transfer corresponding channel, the NMIF
bit in DMAOR, and the AE bit are all cleared to 0.
Clearing the DME bit to 0 can terminate the DMA
transfer on all channels.
0: DMA transfer is disabled on all channels
1: DMA transfer is enabled on all channels
Section 9 Direct Memory Access Controller (DMAC)
Rev. 2.00 Dec. 09, 2005 Page 381 of 1152
REJ09B0191-0200