mc68hc912dg128 Freescale Semiconductor, Inc, mc68hc912dg128 Datasheet - Page 57

• Manufacturer Part Number: mc68hc912dg128
• Description: M68hc12 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

3.5.12 Port P
3.5.13 Port S
MC68HC912DG128 — Rev 3.0
MOTOROLA
The four pulse-width modulation channel outputs share general-purpose
port P pins. The PWM function is enabled with the PWEN register.
Enabling PWM pins takes precedence over the general-purpose port.
When pulse-width modulation is not in use, the port pins may be used for
general-purpose I/O.
Register DDRP determines pin direction of port P when used for
general-purpose I/O. When DDRP bits are set, the corresponding pin is
configured for output. On reset the DDRP bits are cleared and the
corresponding pin is configured for input.
When the PUPP bit in the PWCTL register is set, all input pins are pulled
up internally by an active pull-up device. Pull-ups are disabled after reset.
Setting the RDPP bit in the PWCTL register configures all port P outputs
to have reduced drive levels. Levels are at normal drive capability after
reset. The PWCTL register can be read or written anytime after reset.
Refer to
Port S is the 8-bit interface to the standard serial interface consisting of
the two serial communications interfaces (SCI1 and SCI0) and the serial
peripheral interface (SPI) subsystems. Port S pins are available for
general-purpose I/O when standard serial functions are not enabled.
Port S pins serve several functions depending on the various internal
control registers. If WOMS bit in the SC0CR1register is set, the P-
channel drivers of the output buffers are disabled (wire-or mode) for pins
0 through 3. If SWOM bit in the SP0CR1 register is set, the P-channel
drivers of the output buffers are disabled (wire-or mode) for pins 4
through 7. The open drain control affects both the serial and the general-
purpose outputs. If the RDPS bit in the SP0CR2 register is set, Port S
pin drive capabilities are reduced. If PUPS bit in the SP0CR2 register is
set, a pull-up device is activated for each port S pin programmed as a
general purpose input. If the pin is programmed as a general-purpose
output, the pull-up is disconnected from the pin regardless of the state of
PUPS bit. See
Freescale Semiconductor, Inc.
For More Information On This Product,
Pulse Width
Pinout and Signal Descriptions
Go to: www.freescale.com
Multiple Serial
Modulator.
Interface.
Pinout and Signal Descriptions
Technical Data
Port Signals
57