D6417760BP200ADV Renesas Electronics America, D6417760BP200ADV Datasheet - Page 732

• Manufacturer Part Number: D6417760BP200ADV
• Description: IC SUPER H MPU ROMLESS 256BGA
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of D6417760BP200ADV

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: Audio Codec, CAN, EBI/EMI, FIFO, I²C, MFI, MMC, SCI, Serial Sound, SIM, SPI, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 69
• Program Memory Type: ROMless
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

When detecting a parity error, the receiver in T = 1 mode does not return an error signal. The
transmitter does not sample error signals or repeat the disputed data.
The operation sequence is as follows.
1. When the SIM is not in use, the data line is in the high-impedance state, fixed at high level by
2. The transmitter starts transmission of one frame of data. The data frame begins with the start
3. The SIM then returns the data line to high impedance. The data line is held at high level by the
4. The receiver performs a parity check.
5. If the transmitter does not receive an error signal, it transmits the next frame.
Rev. 2.00 Feb. 12, 2010 Page 648 of 1330
REJ09B0554-0200
the pull-up resistance.
bit (Ds: low level). This is followed by eight data bits (D0 to D7) and the parity bit (Dp).
pull-up resistance.
If detecting no parity error and receiving the data normally, the receiver waits for the next
frame, without taking further action.
If a parity error has occurred, the receiver outputs an error signal (DE: low level) for
requesting data repetition in T = 0 mode. After outputting an error signal for the specified
duration, the receiver again sets the signal line to high impedance. The signal line returns to
high level by the pull-up resistance. In T = 1 mode, however, the receiver outputs no error
signal when a parity error occurs.
If the transmitter in T = 0 mode receives an error signal, it repeats the disputed data as in step 2
above. In T = 1 mode, however, the transmitter receives no error signals and performs no
repetition.
Figure 18.2 Data Format Used by the Smart Card Interface
Ds
D0 to D7
Dp
DE
When a parity error occurs in T=1 mode
When a parity error occurs in T=0 mode
When no parity error occurs
Ds
Ds
Ds
Ds
Ds
: Start bit
: Data bits
: Parity bit
: Error signal
D0
D0
D0
D1 D2
D1
D1
D2
Transmitter output
Transmitter output
Transmitter output
D2
D3
D3
D3
D4
D4
D4
D5 D6
D5
D5 D6 D7
D6
D7 Dp
D7
Dp
Dp
Receiver output
DE