DF61657CN35FTV Renesas Electronics America, DF61657CN35FTV Datasheet - Page 152

• Manufacturer Part Number: DF61657CN35FTV
• Description: IC H8SX/1657 MCU FLASH 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of DF61657CN35FTV

• Core Processor: H8SX
• Core Size: 32-Bit
• Speed: 35MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 82
• Program Memory Size: 768KB (768K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• For Use With: 3DK1657 - DEV EVAL KIT FOR H8SX/1657
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 5 Interrupt Controller
Similarly, when an interrupt is requested immediately before the DTC enable bit is changed to
activate the DTC, DTC activation and the interrupt exception handling by the CPU are both
executed. When changing the DTC enable bit, make sure that an interrupt is not requested.
5.8.2
Instructions that disable interrupts immediately after execution are LDC, ANDC, ORC, and
XORC. After any of these instructions is executed, all interrupts including NMI are disabled and
the next instruction is always executed. When the I bit is set by one of these instructions, the new
value becomes valid two states after execution of the instruction ends.
5.8.3
There are times when interrupt acceptance is disabled by the interrupt controller.
The interrupt controller disables interrupt acceptance for a 3-state period after the CPU has
updated the mask level with an LDC, ANDC, ORC, or XORC instruction, and for a period of
writing to the registers of the interrupt controller.
5.8.4
Interrupt operation differs between the EEPMOV.B and the EEPMOV.W instructions.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the transfer is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at the end of the individual transfer cycle. The PC value saved on the
stack in this case is the address of the next instruction. Therefore, if an interrupt is generated
during execution of an EEPMOV.W instruction, the following coding should be used.
Rev. 2.00 Jun. 28, 2007 Page 126 of 864
REJ09B0341-0200
L1:
Instructions that Disable Interrupts
Times when Interrupts are Disabled
Interrupts during Execution of EEPMOV Instruction
EEPMOV.W
MOV.W R4,R4
BNE
L1