TMPM330FWFG Toshiba, TMPM330FWFG Datasheet - Page 379

• Manufacturer Part Number: TMPM330FWFG
• Description: Microcontrollers (MCU) MCU w/ ARM Cortex-M3 128K FLASH, 8K SRAM
• Manufacturer: Toshiba

Specifications of TMPM330FWFG

• Processor Series: TX03
• Core: ARM Cortex M3
• 3rd Party Development Tools: MDK-ARM, RL-ARM, ULINK2
• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 100
• Package: LQFP(14×14)
• Vcc: 3V
• Cpu Mhz: 40
• Ssp (ch) Spi: -
• I2c/sio (ch): 3
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: -
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: 12
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 10
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit
• Lead Free Status / Rohs Status: Details

13.4.1.3
<RMCNC [3:0]> = 0011 (3 cycle)
Registers (RMCxRCR1, RMCxRCR2 and RMCxRCR3,RMCxRCR4) before reception.
(1)
Configure reception operation of a remote control signal with the Remote Control Signal Receive Control
Sampling clock
After sampling
After noise
cancellation
RXINx pin
Preparation
monitored, RMC recognizes that the signal was changed to "Low" after monitoring cycles of "Low"s
specified in <RMCNC>. If "Low" is monitored, RMC recognizes that the signal was changed to "High"
after monitoring cycles of "High" specified in <RMCNC>.
[3:0]> = "0011" (3 cycles). Subsequent to noise cancellation, the signal is changed from "High" to "Low"
upon monitoring 3 cycles of "Low", and the signal is changed from "Low" to "High" upon monitoring
3 cycles of "High".
Configure noise cancelling time with the RMCxRCR4 <RMCNC[3:0]> bit.
The signal which is sampled by a sampling clock is cancelled noise.
RMC monitors a sampled remote control signal in each rising edge of a sampling clock. If "High" is
The following figure shows how RMC operates according to the noise cancel setting of <RMCNC
Settings of Noise Cancelling Time
Page 359
Noise
TMPM330FDFG/FYFG/FWFG