PIC18F4580-I/P Microchip Technology Inc., PIC18F4580-I/P Datasheet - Page 331

• Manufacturer Part Number: PIC18F4580-I/P
• Description: 40 PIN, 32 KB FLASH, 1536 RAM, 36 I/O
• Manufacturer: Microchip Technology Inc.

Specifications of PIC18F4580-I/P

• A/d Inputs: 11-Channel, 10-Bit
• Comparators: 2
• Cpu Speed: 10 MIPS
• Eeprom Memory: 256 Bytes
• Input Output: 36
• Interface: CAN/I2C/SPI/USART
• Memory Type: Flash
• Number Of Bits: 8
• Package Type: 40-pin PDIP
• Programmable Memory: 32K Bytes
• Ram Size: 1.5K Bytes
• Speed: 40 MHz
• Timers: 1-8 bit, 3-16 bit
• Voltage, Range: 2-5.5 V
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

27.0
Absolute Maximum Ratings
Ambient temperature under bias.............................................................................................................-40°C to +125°C
Storage temperature .............................................................................................................................. -65°C to +150°C
Voltage on any pin with respect to V
Voltage on V
Voltage on MCLR with respect to V
Voltage on RA4 with respect to V
Total power dissipation (Note 1) ...............................................................................................................................1.0W
Maximum current out of V
Maximum current into V
Input clamp current, I
Output clamp current, I
Maximum output current sunk by any I/O pin..........................................................................................................25 mA
Maximum output current sourced by any I/O pin ....................................................................................................25 mA
Maximum current sunk by all ports (combined) ....................................................................................................200 mA
Maximum current sourced by all ports (combined) ...............................................................................................200 mA
 2004 Microchip Technology Inc.
Note 1: Power dissipation is calculated as follows:
Note:
2: Voltage spikes below V
ELECTRICAL CHARACTERISTICS
Pdis = V
Thus, a series resistor of 50-100 should be used when applying a “low” level to the MCLR/V
than pulling this pin directly to V
Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions
above those indicated in the operation listings of this specification is not implied. Exposure to maximum
rating conditions for extended periods may affect device reliability.
DD
with respect to V
DD
IK
OK
(V
x {I
DD
I
SS
(V
DD
< 0 or V
pin ..............................................................................................................................250 mA
O
pin ...........................................................................................................................300 mA
– ∑ I
< 0 or V
SS
SS
OH
SS
I
SS
............................................................................................................... 0V to +8.5V
SS
> V
......................................................................................................... -0.3V to +7.5V
(†)
} + ∑ {(V
at the MCLR/V
(Note 2) ......................................................................................... 0V to +13.25V
O
(except V
DD
> V
) .......................................................................................................... ±20 mA
SS
DD
DD
.
) ...................................................................................................±20 mA
DD
– V
, MCLR and RA4) .......................................... -0.3V to (V
OH
PP
) x I
pin, inducing currents greater than 80 mA, may cause latch-up.
OH
} + ∑(V
OL
x I
OL
)
PIC18FXX8
DS41159D-page 329
PP
DD
pin rather
+ 0.3V)