CS1D-DPL02D Omron, CS1D-DPL02D Datasheet - Page 247

• Manufacturer Part Number: CS1D-DPL02D
• Description: CS1D Dual IO Exp
• Manufacturer: Omron

Specifications of CS1D-DPL02D

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Specific PLC Setup Settings
6-2-10 Comms Unit Duplex Tab Page
Active-Standby Settings (Check Boxes for Communications Units 0 to 15)
212
121
Word
Programming
Address in
Console
0 to 15
Bit(s)
0: Disable duplex
settings for Commu-
nications Units
1: Enable duplex
settings for Commu-
nications Units
Default: 0
Note CX-Programmer version 3.@ supports active-standby duplex communica-
Settings
There are two methods that can be used for duplex communications: Active-
standby and primary-secondary. There are options available for both in the
PLC Setup. The methods that are used depends on the Communications
Units. Refer to the operation manuals for the Communications Units for
details.
tions, but it does not support primary-secondary communications for CS1D
Communications Units.
These settings (individual bits) enable or
disable duplex settings for individual Com-
munications Units. Bits 00 to 15 correspond
to unit numbers 0 to F.
To use Duplex Communications Units, set-
ting them must be enabled here, and then
either the I/O tables must be created auto-
matically, or they must be edited to specify
active and standby modes for the Communi-
cations Units and then transferred to the
active CPU Unit.
If necessary, the I/O table editing operations
of the CX-Programmer can be used to spec-
ify the slot in which the standby Communi-
cations Unit is mounted.
Function
---
flags and
Related
words
Section 6-2
At startup
ting’s effec-
New set-
tiveness