AM186ES Advanced Micro Devices, AM186ES Datasheet - Page 81

• Manufacturer Part Number: AM186ES
• Description: microcontrollers provide a low-cost/ high-performance solution for embedded system designers who wish to use the x86 architecture.
• Manufacturer: Advanced Micro Devices

Bit 7: Pin Selector (EX)—This bit determines whether the PCS6–PCS5 pins are configured
as chip selects or as alternate outputs for A2–A1. When this bit is set to 1, PCS6–PCS5
are configured as peripheral chip select pins. When EX is set to 0, PCS5 becomes address
bit A1 and PCS6 becomes address bit A2.
Bit 6: Memory/ I/O Space Selector (MS)—This bit determines whether the PCS pins are
active during memory bus cycles or I/O bus cycles. When MS is set to 1, the PCS outputs
are active for memory bus cycles. When MS is set to 0, the PCS outputs are active for I/O
bus cycles.
Bits 5–3: Reserved—Set to 1.
Bit 2: Ready Mode (R2)—This bit applies only to the PCS6–PCS5 chip selects. If R2 is
set to 0, external ready is required. If R2 is set to 1, external ready is ignored. In each case,
the processor also uses the value of the R1–R0 bits to determine the number of wait states
to insert.
Bits 1–0: Wait-State Value (R1–R0)—These bits apply only to the PCS6–PCS5 chip
selects. The value of R1–R0 determines the number of wait states inserted into an access
to the PCS memory or I/O area. From zero to three wait states can be inserted (R1–R0 =
00b to 11b).
Chip Select Unit
5-11