SAM9X25 Atmel Corporation, SAM9X25 Datasheet - Page 847

• Manufacturer Part Number: SAM9X25
• Manufacturer: Atmel Corporation

Specifications of SAM9X25

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 105
• Ext Interrupts: 105
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 3
• Uart: 7
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 2
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 12
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: DDR/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Figure 39-48. Slave Node Configuration, NACT = PUBLISH
Figure 39-49. Slave Node Configuration, NACT = SUBSCRIBE
11054A–ATARM–27-Jul-11
11054A–ATARM–27-Jul-11
TXRDY
RXRDY
LINIDRX
US_LINID
US_RHR
LINTC
TXRDY
RXRDY
LINIDRX
US_LINID
US_THR
LINTC
Write
Read
Read
Read
Break
Break
What comes next depends on the NACT configuration:
Synch
Synch
• Case 1: NACT = PUBLISH, the LIN controller sends the response
• Case 2: NACT = SUBSCRIBE, the USART receives the response
• Case 3: NACT = IGNORE, the USART is not concerned by the response
– Wait until TXRDY in US_CSR rises
– Write TCHR in US_THR to send a byte
– If all the data have not been written, redo the two previous steps
– Wait until LINTC in US_CSR rises
– Check the LIN errors
– Wait until RXRDY in US_CSR rises
– Read RCHR in US_RHR
– If all the data have not been read, redo the two previous steps
– Wait until LINTC in US_CSR rises
– Check the LIN errors
– Wait until LINTC in US_CSR rises
– Check the LIN errors
Protected
Protected
Identifier
Identifier
Data 1
Data 2
Data 1
Data 1
Data 1
Data 3
Data N-2
Data N
Data N-1
Data N-1
Data N-1
Data N
Data N
Data N
Checksum
Checksum
SAM9X25
SAM9X25
847
847