D13007VX13V Renesas Electronics America, D13007VX13V Datasheet - Page 265

• Manufacturer Part Number: D13007VX13V
• Description: MCU 3V 0K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of D13007VX13V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 13MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 35
• Program Memory Type: ROMless
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

7.4.11
NMI interrupts do not affect DMAC operations in short address mode.
If an NMI interrupt occurs during a transfer in full address mode, the DMAC suspends operations.
In full address mode, a channel is enabled when its DTE and DTME bits are both set to 1. NMI
input clears the DTME bit to 0. After transferring the current byte or word, the DMAC releases the
bus to the CPU. In normal mode, the suspended transfer resumes when the CPU sets the DTME
bit to 1 again. Check that the DTE bit is set to 1 and the DTME bit is cleared to 0 before setting
the DTME bit to 1.
Figure 7.21 shows the procedure for resuming a DMAC transfer in normal mode on channel 0
after the transfer was halted by NMI input.
For information about NMI interrupts in block transfer mode, see section 7.6.6, NMI Interrupts
and Block Transfer Mode.
Figure 7.21 Procedure for Resuming a DMAC Transfer Halted by NMI (Example)
Resuming DMAC transfer
DMA transfer continues
NMI Interrupts and DMAC
in normal mode
Set DTME to 1
DTME = 0
Yes
DTE = 1
No
1
2
End
1.
2.
Rev.5.00 Sep. 12, 2007 Page 235 of 764
Check that DTE = 1 and DTME = 0.
Read DTCRB while DTME = 0,
then write 1 in the DTME bit.
7. DMA Controller
REJ09B0396-0500