AT32UC3L0256 Atmel Corporation, AT32UC3L0256 Datasheet - Page 399

• Manufacturer Part Number: AT32UC3L0256
• Manufacturer: Atmel Corporation

Specifications of AT32UC3L0256

• Flash (kbytes): 256 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 50 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 460
• Analog Comparators: 8
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.62 to 3.6
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 35
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

Figure 19-28. Master Node Configuration, NACT=SUBSCRIBE
Figure 19-29. Master Node Configuration, NACT=IGNORE
19.6.7.2
32145A–12/2011
TXRDY
RXRDY
LINTC
TXRDY
RXRDY
LINTC
Read
LINIR
LINIR
RHR
Write
Write
Slave Node Configuration
Break
Break
Header
This is identical to the master node configuration above, except for:
IMPORTANT: if NACT=PUBLISH, and this field is already correct, the LINMR register must still
be written with this value in order to set TXRDY, and to request the corresponding Peripheral
DMA Controller write transfer.
The different NACT settings result in the same procedure as for the master node, see
Synch
Synch
Header
• LIN mode selected in MR.MODE is slave
• When the baud rate is configured, wait until CSR.LINID is a one, then;
• Check for LINISFE and LINPE errors, clear errors and LINIDby writing a one to RSTSTA
• Read IDCHR
• Configure the frame transfer by writing to NACT, PARDIS, CHKDIS, CHKTYPE, DLCM, and
DLC in LINMR
Protected
Protected
Identifier
Identifier
Data3
Data3
Frame slot = TFrame_Maximum
Response
Response
space
Frame slot = TFrame_Maximum
space
Frame
Frame
Data 1
Data 1
Data 1
Data N-2
Response
Data N-1
Data N-1
Response
Data N-1
AT32UC3L0128/256
Data N
Data N
Data N
Checksum
Checksum
FSDIS=1
FSDIS=1
space
frame
Inter-
space
frame
Inter-
FSDIS=0
FSDIS=0
page
397.
399