AT91SAM9G45-EKES Atmel, AT91SAM9G45-EKES Datasheet - Page 1058

• Manufacturer Part Number: AT91SAM9G45-EKES
• Description: KIT EVAL FOR AT91SAM9G45
• Manufacturer: Atmel
• Series: AT91SAM Smart ARMr
• Type: MCUr

Specifications of AT91SAM9G45-EKES

• Contents: Board
• Processor To Be Evaluated: SAM9G45
• Data Bus Width: 32 bit
• Interface Type: I2C, SPI, UART
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: - 10 C
• Operating Supply Voltage: 1.8 V to 3.3 V
• For Use With/related Products: AT91SAM9G45
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q4626953

43.7.3.1
43.7.3.2
1058
AT91SAM9G45
AC97 Controller Setup
Transmit Operation
The following operations must be performed in order to bring the AC97 Controller into an operat-
ing state:
The application must perform the following steps in order to send data via a channel to the AC97
Codec:
Once data has been transferred to the Channel x Shift Register, the TXRDY flag is automatically
set by the AC97 Controller which allows the application to start a new write action. The applica-
tion can also wait for an interrupt notice associated with TXRDY in order to send data. The
interrupt remains active until TXRDY flag is cleared.
1. Enable the AC97 Controller clock in the PMC controller.
2. Turn on AC97 function by enabling the ENA bit in AC97 Controller Mode Register
3. Configure the input channel assignment by controlling the AC97 Controller Input
4. Configure the output channel assignment by controlling the AC97 Controller Input
5. Configure sample width for Channel A, Channel Bby writing the SIZE bit field in AC97C
6. Configure data Endianness for Channel A, Channel B by writing CEM bit field in
7. Configure the PIO controller to drive the RESET signal of the external Codec. The
8. Enable Channel A and/or Channel B by writing CEN bit field in AC97C_CxMR register.
• Check if previous data has been sent by polling TXRDY flag in the AC97C Channel x Status
• Write data to the AC97 Controller Channel x Transmit Holding Register (AC97C_CxTHR).
Register (AC97_CxSR). x being one of the 2 channels.
(AC97C_MR).
Assignment Register (AC97C_ICA).
Assignment Register (AC97C_OCA).
Channel x Mode Register (AC97C_CAMR), (AC97C_CBMR). The application can write
10, 16, 18,or 20-bit wide PCM samples through the AC97 interface and they will be
transferred into 20-bit wide slots.
(AC97C_CAMR), (AC97C_CBMR) register. Data on the AC-link are shifted MSB first.
The application can write little- or big-endian data to the AC97 Controller interface.
RESET signal must fulfill external AC97 Codec timing requirements.
6438F–ATARM–21-Jun-10