ATxmega32D4 Atmel Corporation, ATxmega32D4 Datasheet - Page 221
![no-image](/images/manufacturer_photos/0/0/79/atmel_corporation_sml.jpg)
ATxmega32D4
Manufacturer Part Number
ATxmega32D4
Description
Manufacturer
Atmel Corporation
Specifications of ATxmega32D4
Flash (kbytes)
32 Kbytes
Pin Count
44
Max. Operating Frequency
32 MHz
Cpu
8-bit AVR
# Of Touch Channels
16
Hardware Qtouch Acquisition
No
Max I/o Pins
34
Ext Interrupts
34
Usb Speed
No
Usb Interface
No
Spi
4
Twi (i2c)
2
Uart
2
Graphic Lcd
No
Video Decoder
No
Camera Interface
No
Adc Channels
12
Adc Resolution (bits)
12
Adc Speed (ksps)
200
Analog Comparators
2
Resistive Touch Screen
No
Temp. Sensor
Yes
Crypto Engine
No
Sram (kbytes)
4
Eeprom (bytes)
1024
Self Program Memory
YES
Dram Memory
No
Nand Interface
No
Picopower
Yes
Temp. Range (deg C)
-40 to 85
I/o Supply Class
1.6 to 3.6
Operating Voltage (vcc)
1.6 to 3.6
Fpu
No
Mpu / Mmu
no / no
Timers
4
Output Compare Channels
14
Input Capture Channels
14
Pwm Channels
14
32khz Rtc
Yes
Calibrated Rc Oscillator
Yes
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ATxmega32D4-AU
Manufacturer:
Atmel
Quantity:
123
Part Number:
ATxmega32D4-AU
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Company:
Part Number:
ATxmega32D4-CU
Manufacturer:
Maxim
Quantity:
71
Company:
Part Number:
ATxmega32D4-MH
Manufacturer:
Atmel
Quantity:
1 910
Company:
Part Number:
ATxmega32D4-MH
Manufacturer:
Atmel
Quantity:
1 704
Part Number:
ATxmega32D4-MH
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
19.2.1
8210B–AVR–04/10
Event System Filtering
For transmission, three pulse modulation schemes are available:
For reception, a minimum high-level pulse width for the pulse to be decoded as a logical 0 can
be selected. Shorter pulses will then be discarded and the bit will be decoded to logical 1 as if no
pulse where received.
One IRCOM will be available for use with any USART in the device. The module can only be
used in combination with one USART at a time, thus IRCOM mode must not be set for more
than one USART at a time. This must be ensured in the user software.
The Event System can be used as the receiver input. This enables IRCOM or USART input from
other I/O pins or sources than the corresponding RX pin. If Event System input is enabled, input
from the USART's RX pin is automatically disabled. The Event System has Digital Input Filter
(DIF) on the Event Channels, that can be used for filtering. Refer to
on page
• 3/16 of baud rate period.
• Fixed programmable pulse time based on the Peripheral Clock speed.
• Pulse modulation disabled.
65” for details on using the Event System.
Section 6. ”Event System”
XMEGA D
221