OM13006,598 NXP Semiconductors, OM13006,598 Datasheet - Page 214

• Manufacturer Part Number: OM13006,598
• Description: BOARD EVAL EM773 METER EU PLUG
• Manufacturer: NXP Semiconductors
• Type: Other Power Managementr

Specifications of OM13006,598

• Design Resources: Plug Meter Schematics, Gerber Files USB Dongle Schematics, Gerber Files
• Main Purpose: Power Management, Energy/Power Meter
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: EM773FHN33,551
• Interface Type: USB
• Maximum Operating Temperature: + 150 C
• Operating Supply Voltage: 1.8 V to 3.6 V
• Product: Power Management Development Tools
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Primary Attributes: -
• Secondary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: EM773, OL2381
• Other names: 568-6681

NXP Semiconductors
UM10415
User manual
18.4.13 Compare <address1> <address2> <no of bytes> (UART ISP)
18.4.14 ReadUID (UART ISP)
18.4.15 UART ISP Return Codes
Table 199. UART ISP Compare command
Table 200. UART ISP ReadUID command
Table 201. UART ISP Return Codes Summary
Command
Input
Return Code CMD_SUCCESS | (Source and destination data are equal)
Description
Example
Command
Input
Return Code CMD_SUCCESS followed by four 32-bit words of E-sort test information in ASCII
Description
Return
Code
0
1
2
3
4
5
Mnemonic
CMD_SUCCESS
INVALID_COMMAND
SRC_ADDR_ERROR
DST_ADDR_ERROR
SRC_ADDR_NOT_MAPPED
DST_ADDR_NOT_MAPPED
M
Address1 (DST): Starting flash or RAM address of data bytes to be compared.
This address should be a word boundary.
Address2 (SRC): Starting flash or RAM address of data bytes to be compared.
This address should be a word boundary.
Number of Bytes: Number of bytes to be compared; should be a multiple of 4.
COMPARE_ERROR | (Followed by the offset of first mismatch)
COUNT_ERROR (Byte count is not a multiple of 4) |
ADDR_ERROR |
ADDR_NOT_MAPPED |
PARAM_ERROR |
This command is used to compare the memory contents at two locations.
Compare result may not be correct when source or destination address
contains any of the first 512 bytes starting from address zero. First 512 bytes
are re-mapped to boot ROM
"M 8192 268468224 4<CR><LF>" compares 4 bytes from the RAM address
0x1000 8000 to the 4 bytes from the flash address 0x2000.
N
None
format. The word sent at the lowest address is sent first.
This command is used to read the unique ID.
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 10 September 2010
Chapter 18: EM773 Flash memory programming firmware
Invalid command.
Source address is not on word boundary.
Source address is not mapped in the memory map.
Description
Command is executed successfully. Sent by ISP
handler only when command given by the host has
been completely and successfully executed.
Destination address is not on a correct boundary.
Count value is taken in to consideration where
applicable.
Destination address is not mapped in the memory
map. Count value is taken in to consideration
where applicable.
UM10415
© NXP B.V. 2010. All rights reserved.
214 of 310