OM13006,598 NXP Semiconductors, OM13006,598 Datasheet - Page 213

• Manufacturer Part Number: OM13006,598
• Description: BOARD EVAL EM773 METER EU PLUG
• Manufacturer: NXP Semiconductors
• Type: Other Power Managementr

Specifications of OM13006,598

• Design Resources: Plug Meter Schematics, Gerber Files USB Dongle Schematics, Gerber Files
• Main Purpose: Power Management, Energy/Power Meter
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: EM773FHN33,551
• Interface Type: USB
• Maximum Operating Temperature: + 150 C
• Operating Supply Voltage: 1.8 V to 3.6 V
• Product: Power Management Development Tools
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Primary Attributes: -
• Secondary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: EM773, OL2381
• Other names: 568-6681

NXP Semiconductors
UM10415
User manual
18.4.10 Blank check sector(s) <sector number> <end sector number> (UART
18.4.12 Read Boot code version number (UART ISP)
18.4.11 Read Part Identification number (UART ISP)
ISP)
Table 195. UART ISP Blank check sector command
Table 196. UART ISP Read Part Identification command
Table 197. EM773 part identification numbers
Table 198. UART ISP Read Boot Code version number command
Command
Input
Return Code CMD_SUCCESS |
Description
Example
Command
Input
Return Code CMD_SUCCESS followed by part identification number in ASCII (see
Description
Device
Command
Input
Return Code CMD_SUCCESS followed by 2 bytes of boot code version number in ASCII format.
Description
EM773FHN33/301
I
Start Sector Number:
End Sector Number: Should be greater than or equal to start sector number.
SECTOR_NOT_BLANK (followed by <Offset of the first non blank word location>
<Contents of non blank word location>) |
INVALID_SECTOR |
PARAM_ERROR |
This command is used to blank check one or more sectors of on-chip flash memory.
Blank check on sector 0 always fails as first 64 bytes are re-mapped to flash
boot block.
"I 2 3<CR><LF>" blank checks the flash sectors 2 and 3.
J
None.
“EM773 part identification
This command is used to read the part identification number.
K
None
It is to be interpreted as <byte1(Major)>.<byte0(Minor)>.
This command is used to read the boot code version number.
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 10 September 2010
ASCII/dec coding
71569451
Chapter 18: EM773 Flash memory programming firmware
numbers”).
Hex coding
0x0444 102B
UM10415
© NXP B.V. 2010. All rights reserved.
Table 197
213 of 310