HD64F2676VFC33 Renesas Electronics America, HD64F2676VFC33 Datasheet - Page 885

• Manufacturer Part Number: HD64F2676VFC33
• Description: IC H8S MCU FLASH 256K 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2676VFC33

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: IrDA, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 103
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

This section gives information on the on-chip I/O registers and is configured as described below.
1. Register Addresses (by functional module, in order of the corresponding section numbers)
2. Register Bits
3. Register States in Each Operating Mode
23.1
Entries under Access size indicates numbers of bits.
Note: Access to undefined or reserved addresses is prohibited. Since operation or continued
Descriptions by functional module, in order of the corresponding section numbers
Entries that consist of
Access to reserved addresses which are not described in this list is prohibited.
When registers consist of 16 or 32 bits, the addresses of the MSBs are given, on the
presumption of a big-endian system.
Bit configurations of the registers are described in the same order as the Register Addresses
(by functional module, in order of the corresponding section numbers).
Reserved bits are indicated by
No entry in the bit-name column indicates that the whole register is allocated as a counter or
for holding data.
When registers consist of 16 or 32 bits, bits are described from the MSB side.
The order in which bytes are described is on the presumption of a big-endian system.
Register states are described in the same order as the Register Addresses (by functional
module, in order of the corresponding section numbers).
For the initial state of each bit, refer to the description of the register in the corresponding
section.
The register states described are for the basic operating modes. If there is a specific reset for an
on-chip module, refer to the section on that on-chip module.
operation is not guaranteed when these registers are accessed, do not attempt such access.
(by functional module, in order of the corresponding section
numbers)
Register Addresses
Section 23 List of Registers
lines are for separation of the functional modules.
in the bit name.
Rev. 3.00 Mar 17, 2006 page 833 of 926
Section 23 List of Registers
REJ09B0283-0300