DF2148ATE20 Renesas Electronics America, DF2148ATE20 Datasheet - Page 515

• Manufacturer Part Number: DF2148ATE20
• Description: IC H8S MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2148ATE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: Host Interface, I²C, IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2148ATE20; HD64F2148ATE20

In serial transmission, the SCI operates as described below.
1. The SCI monitors the TDRE flag in SSR, and if it is 0, recognizes that data has been written to
2. After transferring data from TDR to TSR, the SCI sets the TDRE flag to 1 and starts
3. The SCI checks the TDRE flag at the timing for sending the stop bit.
Figure 15.11 shows an example of SCI operation for transmission using a multiprocessor format.
TDR, and transfers the data from TDR to TSR.
transmission.
If the TIE bit is set to 1 at this time, a transmit-data-empty interrupt (TXI) is generated.
The serial transmit data is sent from the TxD pin in the following order.
a. Start bit:
b. Transmit data:
c. Multiprocessor bit
d. Stop bit(s):
e. Mark state:
If the TDRE flag is cleared to 0, data is transferred from TDR to TSR, the stop bit is sent, and
then serial transmission of the next frame is started.
If the TDRE flag is set to 1, the TEND flag in SSR is set to 1, the stop bit is sent, and then the
mark state is entered in which 1 is output continuously. If the TEIE bit in SCR is set to 1 at this
time, a transmit-end interrupt (TEI) request is generated.
One 0-bit is output.
8-bit or 7-bit data is output in LSB-first order.
One multiprocessor bit (MPBT value) is output.
One or two 1-bits (stop bits) are output.
1 is output continuously until the start bit that starts the next transmission is sent.
Section 15 Serial Communication Interface (SCI, IrDA)
Rev. 4.00 Sep 27, 2006 page 469 of 1130
REJ09B0327-0400