UPD78F0138HGK-9ET-A Renesas Electronics America, UPD78F0138HGK-9ET-A Datasheet - Page 451

• Manufacturer Part Number: UPD78F0138HGK-9ET-A
• Description: MCU 8BIT 60K FLASH 64TQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx1+r

Specifications of UPD78F0138HGK-9ET-A

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: 3-Wire SIO, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 42
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

<R>
<R>
26.7.3 Selecting communication mode
the dedicated flash memory programming mode is entered.
programmer.
Notes 1. Selection items for Standard settings on FlashPro4.
Caution When UART6 is selected, the receive clock is calculated based on the reset command sent from the
UART
(UART6)
3-wire serial I/O
(CSI10)
3-wire serial I/O with
handshake supported
(CSI10 + HS)
Communication Mode
In the 78K0/KE1+, a communication mode is selected by inputting pulses (up to 11 pulses) to the FLMD0 pin after
The following table shows the relationship between the number of pulses and communication modes.
2. The possible setting range differs depending on the voltage. For details, refer to the chapters of electrical
3. When peripheral hardware clock frequency is 2.5 MHz or less, this cannot be selected.
4. Because factors other than the baud rate error, such as the signal waveform slew, also affect UART
dedicated flash programmer after the FLMD0 pulse has been received.
specifications.
communication, thoroughly evaluate the slew as well as the baud rate error.
UART-ch0
SIO-ch0
SIO-H/S
Port
9600, 19200, 31250,
38400, 76800,
153600
2.4 kHz to 2.5 MHz
2.4 kHz to 2.5 MHz
Note 3
Table 26-8. Communication Modes
Speed
CHAPTER 26 FLASH MEMORY
bps
User’s Manual U16899EJ3V0UD
Note 4
Standard Setting
Optional
On Target
Note 1
These FLMD0 pulses are generated by the flash
2 MHz to
16 MHz
Frequency
Note 2
1.0
Multiply Rate
TxD6, RxD6
SO10, SI10,
SCK10
SO10, SI10,
SCK10,
HS/P15
Pins Used
Number of
0
8
11
FLMD0
Pulses
449